Mustang Ii Rack And Pinion High Pressure Port

Uses 910 4047 6an adapter fittings.

Mustang ii rack and pinion high pressure port.

Check here for special coupons and promotions. The pressure port in the rack is the 1 2 20 port. Transfer the check valve to the replacement unit. Your order may be eligible for ship to home and shipping is free on all online orders of 35 00.

Work out your hose routing and decide where to use each hose end extra hose ends and hose are available. The pressure line in this kit has a 5 8 18 male inverted flare fitting at the power steering pump end along with a 6an to an 9 16 18 14mm 1 5 male o ring fitting on the rack end. The return port is m16 1 5 o ring. Order rack pinion complete unit for your 1978 ford mustang ii and pick it up in store make your purchase find a store near you and get directions.

This video explains plainly which port on the mustang fox body and sn 95 rack and pinions are the high pressure port and which is the low pressure return port. Return hose will normally need to be cut to length. 3 4 36 spline input shaft. Rack has 9 16 18 female o ring high pressure inlet and 5 8 18 female o ring low pressure outlet return line threaded ports.

Stan the small port is high pressure big port is low pressure. Begin the installation by assembling the proper adapters into the pump and rack pinion. Chevy which has a chevy pump with a mustang power rack pinion. This power rack has a v style input shaft and uses the same tie rod ends as the mustang ii rack.

Use the figures above to determine the correct port for the check valve. Replacement sku for rack and pinion hard lines is 910 35344. The pressure port is m14 1 5 o ring. Must use offset bushings 910 34342 to mount to original mustang ii crossmembers.

The kit comes with 90ohose ends. This set adapts an aftermarket 1982 1988 t bird cougar type rack or our 91034340 pow rack to a gm style pump. The high pressure fitting is the m14x1 5 thread port which is toward the front of the rack and the return fitting is m16x1 5 thread port that is at the rear closest to the pinion input shaft. An adapters on both rack ports and the pump pressure port.

Refer to protech 22 0010 for more information.